You must enable javascript to use this site!

Installation

The installation of FYES system can be considered as accession, extension or a modification of the electrical installation in the place. The special material needed, except of the conventional electrical, concerns the common connections of the switches on the wall and the electric board.

The special cabling usually needed for installing automations, alarm systems etc. is minified and simplified, while the only needed additional cabling is a 2 couple cable ( the green one in the figure below) for feeding and transmitting the CAN bus data. In each wall module can be connected up to four independent lines of electrical loads (lights, blinds, plugs, air conditioners, etc.) following the classic way of wiring.

The wiring of the sensors in the system (blue in the diagram below) very much simplified by the fact that the sensors are connected to the nearest peripheral unit and not in a remote center.


© Copyright 2019 FYES
Please wait...